Sec t io n 5 : Wi re le ss Co mm an ds
This section describes the CLI commands you use to manage the wireless features on the switch as well as the wireless
access points that a switch manages.
This section contains the following subsections:
•
"Unified Switch Commands" on page 200
•
"Unified Switch Channel and Power Commands" on page 227
•
"Peer Unified Switch Commands" on page 234
•
"Local Access Point Database Commands" on page 237
•
"Wireless Network Commands" on page 244
•
"Access Point Profile Commands" on page 261
•
"Access Point Profile RF Commands" on page 266
•
"Access Point Profile QoS Commands" on page 282
•
"Access Point Profile VAP Commands" on page 286
•
"WS Managed Access Point Commands" on page 287
•
"Access Point Failure Status Commands" on page 305
•
"RF Scan Access Point Status Commands" on page 307
•
"Client Association Status and Statistics Commands" on page 311
•
"Client Failure and Ad Hoc Status Commands" on page 320
•
"WIDS Access Point RF Security Commands" on page 322
•
"Detected Clients Database Commands" on page 331
The commands in this section are in one of three functional groups:
•
Show commands display switch settings, statistics and other information.
•
Configuration Commands configure features and options. For every configuration command there is a show command
that displays the configuration setting.
•
Clear commands clear some or all of the settings to factory defaults.
Wireless Commands
199