D-Link Unified Switch CLI Command Reference
Default
enabled
Format
ip arp inspection vlan vlan-list logging
Mode
Global Config
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated VLAN ranges.
Format
no ip arp inspection vlan vlan-list logging
Mode
Global Config
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
Default
enabled
Format
ip arp inspection trust
Mode
Interface Config
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
Format
no ip arp inspection trust
Mode
Interface Config
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface. Configuring none for the limit means
the interface is not rate limited for Dynamic ARP Inspections.
Note: The user interface will accept a rate limit for a trusted interface, but the limit will not be enforced unless the
interface is configured to be untrusted.
Default
15 pps for rate and 1 second for burst-interval
Format
ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode
Interface Config
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default values of 15 pps and 1 second,
respectively.
Format
no ip arp inspection limit
Mode
Interface Config
© 2009 D-Link Corporation. All Rights Reserved
114