Ws Managed Access Point Commands - D-Link DWS-4000 Series Cli Command Reference

WS M
ANAGED
The commands in this section provide views and management of all status and statistics for an access point managed by
the Unified Switch. This includes views of neighbors within the RF area for each managed AP radio interface. This section
also lists commands available via Privileged EXEC mode to control the WS Managed APs.
wireless ap channel set
This command sets a new channel on the managed AP radio. The channel is not saved in the configuration, it is maintained
until the next time the AP is discovered (AP or switch reset).
Format
wireless ap channel set <macaddr> radio <1-2> <channel>
Mode Privileged EXEC
Parameter Description
macaddr Managed AP MAC Address.
1-2 Radio interface on the managed AP.
channel Channel to set on the managed AP.
wireless ap debug
This command sets the admin user password and enables debug mode on the AP (this allows you telnet access to the AP,
which is normally disabled in managed mode). The debug mode and required password are not saved in the configuration
on the switch, they are only maintained until the next time the AP is discovered (AP or switch reset). This command prompts
for the debug password each time it is invoked.
Note: The AP admin user password will remain changed on the AP.
Default Disable
Format
wireless ap debug <macaddr>
Mode Privileged EXEC
Parameter Description
macaddr Managed AP MAC Address.
no wireless ap debug
The no version of this command disables AP debug mode. The managed AP UI will be disabled as it normally is when the
AP is in managed mode.
Format
no wireless ap debug <macaddr>
Mode Privileged EXEC
A P
CCESS OINT
C
OMMANDS

WS Managed Access Point Commands

287