Table of Contents
Advertisement
no power auto
The no version of this command disables auto power adjustment for the radio.
Format
no power auto
Mode
AP Profile Radio Config
power default
This command configures a power setting for the radio. When auto power adjustment is enabled, this indicates an initial
default power setting; otherwise this indicates a fixed power setting.
Default
100%
Format
power default <0-100>
Mode
AP Profile Radio Config
Parameter
Description
0-100
Default transmit power percentage.
no power default
The no version of this command configures the default power setting to its default value.
Format
no power default
Mode
AP Profile Radio Config
rate
This command is used to configure the list of supported and basic client data rates for the radio. The supported rates are
those the AP will allow when setting up communications with client stations. The basic rates are the list of data rates that all
stations associating with the AP must support.
Default
• 802.11a supported: 6, 9, 12, 18, 24, 36, 48, 54 Mbps
• 802.11a basic: 6, 12, 24 Mbps
• 802.11b/g supported: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps
• 802.11b/g basic: 1, 2, 5.5, 11 Mbps
Format
rate {basic | supported} <value>
Mode
AP Profile Radio Config
Parameter
Description
value
A valid data rate in Mbps based on radio mode.
no rate
The no version of this command is used to remove a basic or supported data rate from the corresponding list.
Access Point Profile RF Commands
273
Advertisement
Table of Contents
