D-Link DWS-4000 Series Cli Command Reference page 277

Default Disabled
Format
station-isolation
Mode AP Profile Radio Config
no station-isolation
The no version of this command disables the station isolation mode on the radio.
Format
no station-isolation
Mode AP Profile Radio Config
rate-limit
This command is used to enable broadcast and multicast traffic rate limiting on the radio. If no optional parameters are
entered, the command enables rate limiting on the radio with the default values.
Default • rate-limit, Disabled
• rate-limit normal, 50 packets per second
• rate-limit burst, 75 packets per second
Format
rate-limit [{normal <1-50> | burst <1-75>}]
Mode AP Profile Radio Config
Parameter Description
normal Configures the rate limit for normal traffic; all traffic below this limit is transmitted.
burst Configures the burst traffic rate. Traffic can occur in bursts up to this value before all traffic is
considered to exceed the limit.
no rate-limit
The no version of this command is used to either disable broadcast/multicast traffic rate limiting, or to return the configured
rate limits to the default values. If no parameters are entered, rate limiting is disabled on the radio. If the optional normal or
burst parameters are entered, the specified rate is set to its default value.
Format
no rate-limit [{normal | burst }]
Mode AP Profile Radio Config
beacon-interval
The command configures the beacon interval for the radio. The beacon interval indicates the interval at which the AP radio
transmits beacon frames.
Default 100 milliseconds
Format
beacon-interval <20-2000>
Mode AP Profile Radio Config
Access Point Profile RF Commands
269