D-Link DWS-4000 Series Cli Command Reference page 214

D-Link Unified Switch CLI Command Reference
Parameter Description
rf-scan Time in hours to maintain an entry obtained from an RF scan.
detected-client Time in hours to maintain an entry in the detected clients database.
0,1-168 Time in hours from 0 to 168. A value of 0 indicates that entries should never age out.
no agetime
The no version of this command returns the configured entry age time to the default.
Format
no agetime {ad-hoc | ap-failure | client-failure | rf-scan |detected-client}
Mode Wireless Config
peer-switch configuration
This command enables peer switch configuration for the wireless system. When a group is enabled, the corresponding
configuration is applied to one or more peer switches during a peer switch configuration request. If no parameters are
specified, then all switch configuration groups are enabled.
Default • ap-database
• ap-profile - Enable,
• captive-portal - Enable
• channel-power - Enable,
• discovery
• global
• known-client – Enable
• radius-client – Enable
Format
peer-switch configuration [{ap-database|ap-profile|captive-portal|channel-
power|discovery|global|known-client|radius-client}]
Mode Wireless Config
Parameter Description
ap-database Enable/Disable AP database configuration push to peer switches.
ap-profile Enable/Disable AP profile and network configuration push to peer switches.
captive-portal Enable/Disable Captive Portal configuration push to peer switches.
channel-power Enable/Disable channel and power configuration push to peer switches.
discovery Enable/Disable discovery configuration push to peer switches.
global Enable/Disable global configuration push to peer switches.
known-client Enable/Disable known client database push to peer switches.
radius-client Enable/Disable RADIUS client configuration push to peer switches.
no peer-switch configuration
The no version of this command disables peer switch configuration for the wireless system. If no parameters are specified,
then all peer switch configurations are disabled.
© 2009 D-Link Corporation. All Rights Reserved
206
- Enable
– Disable,
– Enable,