System Utility And Clear Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Term Definition
Number of Traps The number of traps since the last boot.
Since Last Reset
Trap Log Capacity The number of traps the system can retain.
Number of Traps The number of new traps since the command was last executed.
Since Log Last
Viewed
Log The log number.
System Time Up How long the system had been running at the time the trap was sent.
Trap The text of the trap message.
S U
YSTEM TILITY AND
This section describes the commands you use to help troubleshoot connectivity issues and to restore various configurations
to their factory defaults.
traceroute
Use the traceroute command to discover the routes that packets actually take when traveling to their destination through
the network on a hop-by-hop basis. Traceroute continues to provide a synchronous response when initiated from the CLI.
Default • count: 3 probes
• interval: 3 seconds
• size: 0 bytes
• port: 33434
• maxTtl: 30 hops
• maxFail: 5 probes
• initTtl: 1 hop
•
Format
traceroute <ipaddr|hostname> [initTtl <initTtl>] [maxTtl <maxTtl>]
[maxFail <maxFail>] [interval <interval>] [count <count>]
[port <port>] [size <size>]
Mode Privileged EXEC
Using the options described below, you can specify the initial and maximum time-to-live (TTL) in probe packets, the
maximum number of failures before termination, the number of probes sent for each TTL, and the size of each probe.
Parameter Description
The ipaddr value should be a valid IP address. The hostname value should be a valid
ipaddr|hostname
hostname.
initTtl Use initTtl to specify the initial time-to-live (TTL), the maximum number of router hops between the
local and remote system. Range is 0 to 255.
maxTtl Use maxTtl to specify the maximum TTL. Range is 1 to 255.
maxFail Use maxFail to terminate the traceroute after failing to receive a response for this number of
consecutive probes. Range is 0 to 255.
interval Use interval to specify the time between probes, in seconds. Range is 1 to 60 seconds.
© 2009 D-Link Corporation. All Rights Reserved
430
C C
LEAR OMMANDS