D-Link DWS-4000 Series Cli Command Reference page 354

Hide thumbs Also See for DWS-4000 Series:
Table of Contents

Advertisement

D-Link Unified Switch CLI Command Reference
http port
This command configures an additional HTTP port. Valid port numbers are in the range of 0-65535, excluding port numbers
80 and 443 which are reserved. The HTTP port default is 0 which denotes no additional port and the default port (80) is used.
Default
0
Format
http port <port-num>
Mode
Captive Portal Config
Example: The following shows an example of the command.
(DWS-4026) (Config-CP) #http port 8080<cr>
(DWS-4026) (Config-CP) #no http port<cr>
no http port
This command removes the specified additional HTTP port.
Format
no http port <port-num>
Mode
Captive Portal Config
https port
This command configures an additional HTTPS secure port. The HTTPS secure port default is 0 which denotes no additional
port and the default port (443) is used.
Default
0
Format
https port <port-num>
Mode
Captive Portal Config
Parameter
Description
port-num
Port number in the range of 0-65535.
Example: The following shows an example of the command.
(DWS-4026) (Config-CP) #https port 60000<cr>
(DWS-4026) (Config-CP) #no https port<cr>
no https port
This command set the HTTPS secure port to the default.
Format
no https port <port-num>
Mode
Captive Portal Config
statistics interval
Use this command to configure the interval at which statistics are reported in the Cluster Controller. The reporting interval is
in the range of 0, 15-3600 seconds where 0 disables statistical reporting.
© 2009 D-Link Corporation. All Rights Reserved
346

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dwl-8600ap

Table of Contents