D-Link DWS-4000 Series Cli Command Reference page 190

D-Link Unified Switch CLI Command Reference
no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling the status field stops a virtual router.
Format
no ip vrrp <vrid> mode
Mode Interface Config
ip vrrp ip
This command sets the virtual router IP address value for an interface. The value for <ipaddr> is the IP address which is
to be configured on that interface for VRRP. The parameter <vrid> is the virtual router ID which has an integer value range
from 1 to 255. You can use the optional [secondary] parameter to designate the IP address as a secondary IP address.
Default none
Format
ip vrrp <vrid> ip <ipaddr> [secondary]
Mode Interface Config
no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the interface. To delete the primary
IP address, you must delete the virtual router on the interface.
Format
no ip vrrp <vrid> <ipaddress> secondary
Mode Interface Config
ip vrrp authentication
This command sets the authorization details value for the virtual router configured on a specified interface. The parameter
{none | simple} specifies the authorization type for virtual router configured on the specified interface. The parameter
[key] is optional, it is only required when authorization type is simple text password. The parameter <vrid> is the virtual
router ID which has an integer value ranges from 1 to 255.
Default no authorization
Format
ip vrrp <vrid> authentication {none | simple <key>}
Mode Interface Config
no ip vrrp authentication
This command sets the default authorization details value for the virtual router configured on a specified interface.
Format
no ip vrrp <vrid> authentication
Mode Interface Config
© 2009 D-Link Corporation. All Rights Reserved
182