D-Link DWS-4000 Series Cli Command Reference page 206

D-Link Unified Switch CLI Command Reference
ip icmp echo-reply
Use this command to enable the generation of ICMP Echo Reply messages by the router. By default, the generation of ICMP
Echo Reply messages is enabled.
Default enable
Format
ip icmp echo-reply
Mode Global Config
no ip icmp echo-reply
Use this command to prevent the generation of ICMP Echo Reply messages by the router.
Format
no ip icmp echo-reply
Mode Global Config
ip icmp error-interval
Use this command to limit the rate at which IPv4 ICMP error messages are sent. The rate limit is configured as a token
bucket, with two configurable parameters, burst-size and burst-interval .
The burst-interval specifies how often the token bucket is initialized with burst-size tokens. burst-interval is from 0 to
2147483647 milliseconds (msec).
The burst-size is the number of ICMP error messages that can be sent during one burst-interval . The range is from 1 to 200
messages.
To disable ICMP rate limiting, set burst-interval to zero (0).
Default • burst-interval of 1000 msec.
• burst-size of 100 messages
ip icmp error-interval < burst-interval> [<burst-size>]
Format
Mode Global Config
no ip icmp error-interval
Use the no form of the command to return burst-interval and burst-size to their default values.
Format
no ip icmp error-interval
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
198