Access Point Failure Status Commands - D-Link DWS-4000 Series Cli Command Reference

A P
CCESS OINT
The commands in this section provide views and management of data maintained for access point association and
authentication failures.
clear wireless ap failure list
This command deletes all entries from the AP failure list, entries normally age out according to the configured age time. The
AP failure list includes entries for all APs that have failed to validate or authenticate to the Unified Switch.
Format
clear wireless ap failure list
Mode Privileged EXEC
Example: The following shows an example of the command.
(DWS-4026) #clear wireless ap failure list
Are you sure you want to clear the entire AP failure list? (y/n) y
All AP failure entries cleared.
(DWS-4026) #clear wireless ap failure list
Are you sure you want to clear the entire AP failure list? (y/n) n
AP failure entries not cleared.
show wireless ap failure status
This command displays summary or detailed data for entries in the AP failure list. Entries are added to the list when the
Unified Switch fails to validate or authenticate an AP.
When acting as a Cluster Controller, the peer Unified Switch reported AP failures are also displayed. To identify such entries
in the summary command display, a "*" (asterisk) is used alongside the peer Unified Switch reported AP MAC Address.
Format
show wireless ap [<macaddr>] failure status
Mode Privileged EXEC
Field Description
macaddr The failure AP MAC address.
MAC Address The Ethernet address of the AP.
IP Address The network IP address of the AP.
Reporting Switch Indicates if AP Failure happened with this Unified Switch or peer Unified Switch.
Switch MAC The Ethernet address of the Unified Switch managing the AP.
Address
Switch IP Address The network IP address of the Unified Switch managing the AP.
Last Failure Type Indicates the last type of failure that occurred. If the WS supports the Integrated AP image download
mode and the AP auto upgrade is enabled, the AP is automatically upgraded upon discovery. However,
if no AP image is found on the WS to upgrade the AP, this failure type is reported as 'AP Code Image
Not Available'.
Validation Failure The count of association failures for this AP.
Count
F S
AILURE TATUS

Access Point Failure Status Commands

C
OMMANDS
305