Section 9: Management Commands; Network Interface Commands - D-Link DWS-4000 Series Cli Command Reference

Secti o n 9: Man ag eme nt Co mma nd s
This section describes the management commands available in the Unified Switch CLI.
The Management Commands section contains the following subsections:
• "Network Interface Commands" on page 473
• "Console Port Access Commands" on page 476
• "Telnet Commands" on page 478
• "Secure Shell Commands" on page 481
• "Management Security Commands" on page 483
• "Hypertext Transfer Protocol Commands" on page 485
• "Access Commands" on page 489
• "User Account Commands" on page 490
• "SNMP Commands" on page 496
• "RADIUS Commands" on page 504
• "TACACS+ Commands" on page 515
• "Configuration Scripting Commands" on page 517
• "Pre-login Banner and System Prompt Commands" on page 519
Note: The commands in this section are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configuration command,
there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
N I
ETWORK NTERFACE
This section describes the commands you use to configure a logical interface for management access. To configure the
management VLAN, see "network mgmt_vlan" on page
enable (Privileged EXEC access)
This command gives you access to the Privileged EXEC mode. From the Privileged EXEC mode, you can configure the
network interface.
Format
enable
Mode User EXEC
C
OMMANDS
32.
Management Commands
473