Configuring Ieee 802.1X Authentication; Using The Cli To Configure 802.1X Authentication Information; Table 6: Cli Commands For The 802.1X Supplicant - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
D‐Link‐WLAN‐AP# get management
Property Value
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
vlan‐id 123
interface brtrunk
static‐ip 10.90.90.91
static‐mask 255.0.0.0
ip 10.90.90.91
mask 255.0.0.0
mac 5C:D9:98:2F:52:40
dhcp‐status up
ipv6‐status up
ipv6‐autoconfig‐status up
static‐ipv6 ::
static‐ipv6‐prefix‐length 0
D‐Link‐WLAN‐AP# get untagged‐vlan
Property Value
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
vlan‐id 1
status down
D‐Link‐WLAN‐AP#
Configuring IEEE 802.1X Authentication
On networks that use IEEE 802.1X, port‐based network access control, a supplicant (client) cannot gain access
to the network until the 802.1X authenticator grants access. If your network uses 802.1X, you must configure
802.1X authentication information that the AP can supply to the authenticator.
If your network uses IEEE 802.1X see "Configuring 802.1X Authentication" on page 92 for information about
how to configure 802.1X by using the Web interface.
Using the CLI to Configure 802.1X Authentication Information
The following table shows the commands used to configure the 802.1X supplicant information using the CLI.
Action
View 802.1X supplicant settings
Enable 802.1X supplicant
Disable 802.1X supplicant
Set the 802.1X user name
Set the 802.1s password
D-Link
November 2011
Table 6: CLI Commands for the 802.1X Supplicant
Command
get dot1x‐supplicant
set dot1x‐supplicant status up
set dot1x‐supplicant status down
set dot1x‐supplicant user <name>
set dot1x‐supplicant password <password>
Configuring IEEE 802.1X Authentication
Unified Access Point Administrator's Guide
Page 27