Dns Client Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
show ip dhcp conflict
This command displays address conflicts logged by the DHCP Server. If no IP address is specified, all the conflicting
addresses are displayed.
Format
show ip dhcp conflict [<ip-address>]
Modes • Privileged EXEC
• User EXEC
Term Definition
IP address The IP address of the host as recorded on the DHCP server.
The manner in which the IP address of the hosts were found on the DHCP Server
Detection Method
Detection time The time when the conflict was found.
DNS C C
LIENT
These commands are used in the Domain Name System (DNS), an Internet directory service. DNS is how domain names
are translated into IP addresses. When enabled, the DNS client provides a hostname lookup service to other components
of Unified Switch.
ip domain lookup
Use this command to enable the DNS client.
Default enabled
Format
ip domain lookup
Mode Global Config
no ip domain lookup
Use this command to disable the DNS client.
Format
no ip domain lookup
Mode Global Config
ip domain name
Use this command to define a default domain name that Unified Switch software uses to complete unqualified host names
(names with a domain name). By default, no default domain name is configured in the system. <name> may not be longer
than 255 characters and should not include an initial period. This <name> should be used only when the default domain
name list, configured using the ip domain list command, is empty.
Default none
Format
ip domain name <name>
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
452
OMMANDS
.