D-Link DWS-4000 Series Cli Command Reference page 67

dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled, the dot1x configuration is
retained and can be changed, but is not activated.
Default disabled
Format
dot1x system-auth-control
Mode Global Config
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
no dot1x system-auth-control
Mode Global Config
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on this port. Depending on
the token used and the value (in seconds) passed, various timeout configurable parameters are set. The following tokens
are supported:
Tokens Definition
guest-vlan-period The time, in seconds, for which the authenticator waits to see if any EAPOL packets are received on
a port before authorizing the port and placing the port in the guest vlan (if configured). The guest vlan
timer is only relevant when guest vlan has been configured on that specific port.
reauth-period The value, in seconds, of the timer used by the authenticator state machine on this port to determine
when re-authentication of the supplicant takes place. The reauth-period must be a value in the range
1 - 65535.
quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port to define
periods of time in which it will not attempt to acquire a supplicant. The quiet-period must be a value in
the range 0 - 65535.
tx-period The value, in seconds, of the timer used by the authenticator state machine on this port to determine
when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period must be a
value in the range 1 - 65535.
supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to timeout the
supplicant. The supp-timeout must be a value in the range 1 - 65535.
server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to timeout the
authentication server. The supp-timeout must be a value in the range 1 - 65535.
Port-Based Network Access Control Commands
59