D-Link DWS-4000 Series Cli Command Reference page 157

dos-control smacdmac
Note: This command is only supported on the BCM56224, BCM56514, BCM56624, and BCM56820platforms.
This command enables Source MAC address = Destination MAC address (SMAC = DMAC) Denial of Service protection. If
the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress with SMAC = DMAC,
the packets will be dropped if the mode is enabled.
Default disabled
Format
dos-control smacdmac
Mode Global Config
no dos-control smacdmac
This command disables Source MAC address = Destination MAC address (SMAC = DMAC) Denial of Service protection.
Format
no dos-control smacdmac
Mode Global Config
dos-control tcpport
Note: This command is only supported on the BCM56224, BCM56514, BCM56624, and BCM56820platforms.
This command enables TCP L4 source = destination port number (Source TCP Port = Destination TCP Port) Denial of
Service protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress
with Source TCP Port = Destination TCP Port, the packets will be dropped if the mode is enabled.
Default disabled
Format
dos-control tcpport
Mode Global Config
no dos-control tcpport
This command disables TCP L4 source = destination port number (Source TCP Port = Destination TCP Port) Denial of
Service protection.
Format
no dos-control smacdmac
Mode Global Config
dos-control udpport
Note: This command is only supported on the BCM56224, BCM56514, BCM56624, and BCM56820platforms.
Denial of Service Commands
149