D-Link DWS-4000 Series Cli Command Reference page 94

D-Link Unified Switch CLI Command Reference
Note: This command is only applicable to physical interfaces.
no lacp partner admin state longtimeout
Use this command to set the LACP partner admin state to short timeout.
Format
no lacp partner admin state longtimeout
Mode Interface Config
Note: This command is only applicable to physical interfaces.
lacp partner admin state passive
Use this command to set the LACP partner admin state to passive.
Format
lacp partner admin state passive
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
Format
no lacp partner admin state passive
Mode Interface Config
lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is 0 to 65535.
Default 0x80
Format
lacp partner port-id <port-id>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner port id
Use this command to set the LACP partner port id to the default.
Format
lacp partner port-id
Mode Interface Config
© 2009 D-Link Corporation. All Rights Reserved
86