D-Link DWS-4000 Series Cli Command Reference page 508

D-Link Unified Switch CLI Command Reference
snmptrap
This command adds an SNMP trap receiver. The maximum length of <name> is 16 case-sensitive alphanumeric characters.
The <snmpversion> is the version of SNMP. The version parameter options are snmpv1 or snmpv2.
Example: The following shows an example of the CLI command.
(admin #) snmptrap mytrap 10.12.41.2
Note: The <name> parameter does not need to be unique, however; the <name> and <ipaddr> pair must be
unique. Multiple entries can exist with the same <name>, as long as they are associated with a different
<ipaddr>. The reverse scenario is also acceptable. The <name> is the community name used when sending
the trap to the receiver, but the <name> is not directly associated with the SNMP Community Table, See
server community" on page
Default snmpv2
Format
snmptrap <name> <ipaddr> [snmpversion <snmpversion>]
Mode Global Config
no snmptrap
This command deletes trap receivers for a community.
Format
no snmptrap <name> <ipaddr>
Mode Global Config
snmptrap snmpversion
This command modifies the SNMP version of a trap. The maximum length of <name> is 16 case-sensitive alphanumeric
characters. The <snmpversion> parameter options are snmpv1 or snmpv2.
Note: This command does not support a "no" form.
Default snmpv2
Format
snmptrap snmpversion <name> <ipaddr> <snmpversion>
Mode Global Config
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the same
IP address, the first entry is retained and processed. All duplicate entries are ignored.
Format
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
500
496.
"snmp-