D-Link DWS-4000 Series Cli Command Reference page 233

clear wireless statistics
This clear command resets the global Unified Switch statistics.
Format
clear wireless statistics
Mode Privileged EXEC
Example: The following shows an example of the command.
(DWS-4026) #clear wireless statistics
Are you sure you want to clear the wireless switch statistics? (y/n)y
Sent clear statistics request to the wireless switch.
The statistics are not cleared immediately.
(DWS-4026) #clear wireless statistics
Are you sure you want to clear the wireless switch statistics? (y/n)n
Wireless switch statistics not cleared.
wireless acknowledge-rogue
Use this command to clear the rogue AP state in the RF Scan database for the specified AP. If you do not specify a MAC
address, the rogue AP state will be cleared for all rogue APs.
Format
wireless acknowledge-rogue [<macaddr>]
Mode Privileged Exec
dist-tunnel idle-timeout
Use this command to globally configure the time interval for which L2 distributed tunneled clients can stay idle. Beyond this
time interval, the tunnel is terminated. The parameter idle-timeout is a numeric value in seconds.
Default 120
Format
dist-tunnel idle-timeout <30-3600>
Mode Wireless Config
Parameter Description
idle-timeout The identifier for idle-timeout. The range is 30 to 3600 seconds.
dist-tunnel max-timeout
Use this command to globally configure the maximum time for the L2 distributed tunneled clients beyond which the tunnel is
terminated. The parameter max-timeout is a numeric value in seconds.
Default 7200
Format
dist-tunnel max-timeout <30-86400>
Mode Wireless Config
Unified Switch Commands
225