Table of Contents
Advertisement
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
no distribute-list <1-199> out {static | connected}
Mode
Router RIP Config
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The value of <type> is either
none, simple, or encrypt. The value for authentication key [key] must be 16 bytes or less. The [key] is composed of
standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of <type> is encrypt, a
keyid in the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an authentication key or
authentication key ID.
Default
none
Format
ip rip authentication {none | {simple <key>} | {encrypt <key> <keyid>}}
Mode
Interface Config
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format
no ip rip authentication
Mode
Interface Config
ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to be received.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP version 2, both to
receive packets from either format, or none to not allow any RIP control packets to be received.
Default
both
Format
ip rip receive version {rip1 | rip2 | both | none}
Mode
Interface Config
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be received.
Format
no ip rip receive version
Mode
Interface Config
ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent. The value for <mode>
is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version 1 compatibility mode) which sends RIP
Routing Information Protocol Commands
193
Advertisement
Table of Contents
