D-Link DWS-4000 Series Cli Command Reference page 132

D-Link Unified Switch CLI Command Reference
When you specify a value for <vlan_id>, the following information appears:
Term Definition
VLAN ID The VLAN ID.
IGMP Snooping Indicates whether IGMP Snooping is active on the VLAN.
Admin Mode
Fast Leave Mode Indicates whether IGMP Snooping Fast-leave is active on the VLAN.
Group Membership The amount of time in seconds that a switch will wait for a report from a particular group on a particular
Interval interface, which is participating in the VLAN, before deleting the interface from the entry.This value may
be configured.
Maximum The amount of time the switch waits after it sends a query on an interface, participating in the VLAN,
Response Time because it did not receive a report for a particular group on that interface. This value may be
configured.
Multicast Router The amount of time to wait before removing an interface that is participating in the VLAN from the list
Expiry Time of interfaces with multicast routers attached. The interface is removed if a query is not received. This
value may be configured.
show igmpsnooping mrouter interface
This command displays information about statically configured ports.
Format
show igmpsnooping mrouter interface <slot/port>
Mode Privileged EXEC
Term Definition
Interface The port on which multicast router information is being displayed.
Multicast Router Indicates whether multicast router is statically enabled on the interface.
Attached
VLAN ID The list of VLANs of which the interface is a member.
show igmpsnooping mrouter vlan
This command displays information about statically configured ports.
Format
show igmpsnooping mrouter vlan <slot/port>
Mode Privileged EXEC
Term Definition
Interface The port on which multicast router information is being displayed.
VLAN ID The list of VLANs of which the interface is a member.
© 2009 D-Link Corporation. All Rights Reserved
124