Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
Note: If you use a text-based configuration file, the show running-config command will only display
configured physical interfaces, i.e. if any interface only contains the default configuration, that interface will be
skipped from the show running-config command output. This is true for any configuration mode that contains
nothing but default configuration. That is, the command to enter a particular config mode, followed immediately
by its exit command, are both omitted from the show running-config command output (and hence from the
startup-config file when the system configuration is saved.)
Format
show running-config [all | <scriptname>]
Mode
Privileged EXEC
There are three command modes:
1. <cr> — Press Enter to execute the command.
2. <scriptname> — Script filename for writing active configuration.
3. all — Show all the running configuration on the switch.
Example: The following shows example CLI display captive portal output.
(DWS-4026) #show running config [all]
captive-portal
enable
authentication timeout 300
http port 8080
https port 60000
statistics interval 120
no trapflags client-auth-failure
no trapflags client-connect
no trapflags client-db-full
no trapflags client-disconnect
user group 1
user group 1 name "Default"
configuration 1
name "Default"
enable
protocol https
verification guest
no redirect
session-timeout 0
idle-timeout 0
max-bandwidth-up 0
max-bandwidth-down 0
--More-- or (q)uit
max-input-octets 0
max-output-octets 0
max-total-octets 0
interface 8/1
separator-color "#B70024"
background-color "#BFBFBF"
foreground-color "#999999"
locale 1
code "en"
account-image "login_key.jpg"
account-label
0045006E00740065007200200079006F0075007200200055007300650072006E0061006D0065002E
© 2009 D-Link Corporation. All Rights Reserved
422
Advertisement
Table of Contents
