D-Link DWS-4000 Series Cli Command Reference page 299

Field Description
Location A location description for the AP, this is the value configured in the valid AP database (either locally or
on the RADIUS server).
IP Address The network IP address of the managed AP.
IP Subnet Mask The network mask of the managed AP.
Managing Switch Indicates if the AP is managed by this Unified Switch or a peer Unified Switch.
Switch MAC The Ethernet address of the Unified Switch managing the AP.
Address
Switch IP Address The network IP address of the Unified Switch managing the AP.
Status The current managed state of the AP. The possible values are:
• Discovered - The AP is discovered by the switch, but is not yet authenticated.
• Authenticated - The AP has been validated and authenticated (if authentication is enabled), but it is
not configured.
• Managed - The AP profile configuration has been applied to the AP and it is operating in managed
mode.
• Failed - The Unified Switch lost contact with the AP. A failed entry will remain in the managed AP
database unless you remove it. Note that a managed AP will temporarily show a failed status during
a reset.
Configuration This status indicates if the AP is configured successfully with the assigned profile.
Status
Last Failing The element ID of the last failing configuration element. If the configuration status indicates a partial or
Configuration complete failure, this field indicates the last element that failed during configuration.
Element
Configuration An ASCII string provided by the AP containing an error message for the last failing configuration
Failure Error element.
Debug Mode Indicates whether or not debug mode is enabled on the AP. Debug mode allows you telnet access to
the device.
Code Download Iindicates the current status of a code download request for this AP.
Status
Reset Status Indicates the current status of an AP reset, if one has been initiated.
Profile The AP profile configuration currently applied to the managed AP, the profile is assigned to the AP in
the valid AP database. Note: Once an AP is discovered and managed by the Unified Switch, if the
profile is changed in the valid AP database (either locally or on the RADIUS server) the AP must be
reset to configure with the new profile.
Vendor ID Vendor of the AP software, this is learned from the AP during discovery.
Protocol Version Indicates the protocol version supported by the software on the AP; this is learned from the AP during
discovery.
Software Version Indicates the version of software on the AP; this is learned from the AP during discovery.
Hardware Type Hardware platform for the AP; this is learned from the AP during discovery.
Serial Number Unique Serial number assigned to the AP; this is learned from the AP during discovery.
Part Number Hardware part number for the AP; this is learned from the AP during discovery.
WS Managed Access Point Commands
291