Rf Scan Access Point Status Commands - D-Link DWS-4000 Series Cli Command Reference

RF S A
CAN CCESS
The commands in this section provide views and management of data maintained for all access points known by the Unified
Switch via RF scan data obtained from the managed access points.
clear wireless ap rf-scan list
This command deletes all entries from the RF scan list; entries normally age out according to the configured age time.
Format
clear wireless ap rf-scan list
Mode Privileged EXEC
Example: The following shows an example of the command.
(DWS-4026) #clear wireless ap rf-scan list
Are you sure you want to clear all RF scan entries? (y/n) y
All RF scan entries cleared.
show wireless ap rf-scan status
This command displays summary or detailed data for APs detected via RF scan on the managed APs. If the optional MAC
address parameter is specified, detailed data is displayed.
Format
show wireless ap [<macaddr>] rf-scan status
Mode Privileged EXEC
Field Description
macaddr AP MAC address detected in RF scan.
MAC Address The Ethernet MAC address of the detected AP, this could be a physical radio interface or VAP MAC.
For D-Link APs, this is always a VAP MAC address.
BSSID Basic Service Set Identifier advertised by the AP in the beacon frames.
SSID Service Set ID of the network, this is broadcast in the detected beacon frame.
OUI Vendor name for the MAC address.
Physical Mode Indicates the 802.11 mode being used on the AP.
Channel Transmit channel of the AP.
Status Indicates the managed status of the AP, whether this is a valid AP known to the switch or a Rogue on
the network. The valid values are:
• Managed - The neighbor AP is managed by this switch or another switch within the peer group. The
neighbor AP status can be referenced using its base MAC address.
• Unknown - The neighbor APs detected in the RF Scan are initially categorized as "Unknown" APs.
• Standalone - The AP is managed in standalone mode and configured as a valid AP entry (local or
RADIUS).
• Rogue - The AP Intrusion Detection function has determined that the AP is posing a threat to the
network and categorizes the neighbor AP as "Rogue".
Age Time in seconds since this AP was last detected in an RF scan.
The following parameters are displayed only in the detailed status:
Transmit Rate Indicates the rate at which the AP is currently transmitting data.
P S
OINT TATUS

RF Scan Access Point Status Commands

C
OMMANDS
307