Table of Contents
Advertisement
Term
Definition
4
NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr
The IPv4 address of the server.
no radius server attribute
The
no
version of this command disables the NAS-IP-Address attribute global parameter for RADIUS client. When this
parameter is disabled, the RADIUS client does not send the NAS-IP-Address attribute in RADIUS requests.
Format
no radius server attribute <4> [<ipaddr>]
Mode
Global Config
Example: The following shows an example of the command.
(DWS-4026) (Config) #radius server attribute 4
(DWS-4026) (Config) #radius server attribute 4
radius server host
This command configures the IP address or DNS name to use for communicating with the RADIUS server of a selected
server type. While configuring the IP address or DNS name for the authenticating or accounting servers, you can also
configure the port number and server name. If the authenticating and accounting servers are configured without a name, the
command uses the Default_RADIUS_Auth_Server and Default_RADIUS_Acct_Server as the default names, respectively.
The same name can be configured for more than one authenticating servers and the name should be unique for accounting
servers. The RADIUS client allows the configuration of a maximum 32 authenticating and accounting servers.
If you use the <auth> parameter, the command configures the IP address or hostname to use to connect to a RADIUS
authentication server. You can configure up to 32 servers per RADIUS client. If the maximum number of configured servers
is reached, the command fails until you remove one of the servers by issuing the "no" form of the command. If you use the
optional <port> parameter, the command configures the UDP port number to use when connecting to the configured
RADIUS server. The <port> number range is 1 - 65535, with 1812 being the default value.
Note: To re-configure a RADIUS authentication server to use the default UDP <port>, set the <port>
parameter to 1812.
If you use the <acct> token, the command configures the IP address or hostname to use for the RADIUS accounting server.
You can only configure one accounting server. If an accounting server is currently configured, use the "no" form of the
command to remove it from the configuration. The IP address or hostname you specify must match that of a previously
configured accounting server. If you use the optional <port> parameter, the command configures the UDP port to use when
connecting to the RADIUS accounting server. If a <port> is already configured for the accounting server, the new <port>
replaces the previously configured <port>. The <port> must be a value in the range 0 - 65535, with 1813 being the default.
Note: To re-configure a RADIUS accounting server to use the default UDP <port>, set the <port> parameter
to 1813.
Format
radius server host {auth | acct} {<ipaddr|dnsname>} [name <servername>] [port
<0-65535>]
Mode
Global Config
192.168.37.60
RADIUS Commands
505
Advertisement
Table of Contents
