D-Link DWS-4000 Series Cli Command Reference page 211

Format
no discovery ip-list [<ipaddr>]
Mode Wireless Config
discovery vlan-list
This command adds VLAN IDs on which to send L2 discovery multicast frames. Up to 16 VLAN IDs can be configured. By
default, there is one entry in the list, 1 - Default VLAN.
Default 1 – Default VLAN
Format
discovery vlan-list <1-4094>
Mode Wireless Config
Parameter Description
1-4094 A VLAN ID in the range 1 to 4094.
no discovery vlan-list
The no version of this command deletes the VLAN ID from the discovery list. If no arguments are specified, all VLANs are
deleted from the list except for the first entry. At least one entry must be configured in the list.
Format
no discovery vlan-list [<1-4094>]
Mode Wireless Config
ap validation
This command configures whether to use the local valid AP database or a RADIUS server to validate newly discovered APs.
Default local
Format
ap validation {local | radius}
Mode Wireless Config
Parameter Description
local Local database is used for validating discovered APs.
radius RADIUS server is used for validating discovered APs.
ap authentication
This command enables AP authentication. When enabled, all APs are required to authenticate to the Unified Switch using
a password upon discovery.
Default Disable
Format
ap authentication
Mode Wireless Config
Unified Switch Commands
203