Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
no peer-group
The no version of this command returns the configured peer switch group to the default.
Format
no peer-group
Mode
Wireless Config
discovery method
This command enables various methods used for the discovery of APs and peer switches. If no method is specified, then it
enables all the discovery methods.
Default
IP-Polling – Enable, L2-Multicast - Enable
Format
discovery method [{ip-poll | l2-multicast}]
Mode
Wireless Config
Parameter
Description
ip-poll
Enable IP-based discovery of APs and peer switches.
l2-multicast
Enable L2-based discovery of APs and peer switches.
no discovery method
The no version of this command disables the specified discovery method. If no method is specified, then it disables all the
discovery methods.
Format
no discovery method [{ip-poll | l2-multicast}]
Mode
Wireless Config
discovery ip-list
This command adds an IP address to the list of addresses global to the Unified Switch. The switch polls each address in the
list to discover new access points and peers. The list is used when discovery via IP polling is enabled.
Format
discovery ip-list <ipaddr>
Mode
Wireless Config
Parameter
Description
ipaddr
A valid IP address.
no discovery ip-list
The no version of this command deletes the specified IP address from the polling list. If an argument is not specified, all
entries are deleted from the polling list.
© 2009 D-Link Corporation. All Rights Reserved
202
Advertisement
Table of Contents
