Port Configuration Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
P C
ORT ONFIGURATION
This section describes the commands you use to view and configure port settings.
interface
This command gives you access to the Interface Config mode, which allows you to enable or modify the operation of an
interface (port).
Format
interface <slot/port>
Mode Global Config
auto-negotiate
This command enables automatic negotiation on a port.
Default enabled
Format
auto-negotiate
Mode Interface Config
no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is disabled.
Format
no auto-negotiate
Mode Interface Config
auto-negotiate all
This command enables automatic negotiation on all ports.
Default enabled
Format
auto-negotiate all
Mode Global Config
no auto-negotiate all
This command disables automatic negotiation on all ports.
Format
no auto-negotiate all
Mode Global Config
© 2009 D-Link Corporation. All Rights Reserved
14
C
OMMANDS