Using The Cli To Configure Ethernet Settings; Table 5: Cli Commands For Ethernet Setting - D-Link DWL-8600AP Administrator's Manual

Software User Manual
12/10/09
U CLI C
SING THE TO
Use the commands shown in the following table to view and set values for the Ethernet (wired) interface. For more
information about each setting, see the description for the field in
Action
Get the DNS Name
Set the DNS Name
Get Current Settings for the Ethernet (Wired) Internal
Interface
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID
View the connection type
Use DHCP as the connection type
Use a Static IP as the connection type
Set the Static IP address
Set a Subnet Mask
Set the Default
Gateway
View the DNS Nameserver mode Dynamic= up
Manual=down
Set DNS Nameservers to Use Static IP Addresses
(Dynamic to Manual Mode)
Set DNS Nameservers to Use DHCP IP Addressing
(Manual to Dynamic Mode)
34CSFP6XXUAP-SWUM100-D13
E
ONFIGURE THERNET

Table 5: CLI Commands for Ethernet Setting

S
ETTINGS
Table 12 on page
Command
get host id
set host id <host_name>
For example:
set host id vicky-ap
get management
set management vlan-id <1-4094>
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id <1-4094>
get management dhcp-status
set management dhcp-client status up
set management dhcp-client status down
set management static-ip <ip_address>
Example:
set management static-ip 10.10.12.221
set management static-mask <netmask>
Example:
set management static-mask 255.255.255.0
set static-ip-route gateway <ip_address>
Example:
set static-ip-route gateway 10.10.12.1
get host dns-via-dhcp
set host dns-via-dhcp down
set host static-dns-1 <ip_address>
set host static-dns-2 <ip_address>
Example:
set host static-dns-1 192.168.23.45
set host dns-via-dhcp up
Configuring the Ethernet Settings
D-Link UAP
38.
Page 23