Configuring Ieee 802.1X Authentication; Table 5 - Cli Commands For Ethernet Setting - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
Action
Use DHCP as the connection type
Use a Static IP as the connection type
Set the Static IP address
Set a Subnet Mask
Set the Default Gateway
View the DNS Nameserver mode Dynamic= up
Manual=down
Set DNS Nameservers to Use Static IP Addresses
(Dynamic to Manual Mode)
Set DNS Nameservers to Use DHCP IP Addressing
(Manual to Dynamic Mode)
In the following example, the administrator uses the CLI to set the management VLAN ID to 123 and to disable the
untagged VLAN so that all traffic is tagged with a VLAN ID.
DLINK-WLAN-AP# set management vlan-id 123
DLINK-WLAN-AP# set untagged-vlan status down
DLINK-WLAN-AP# get management
Property
--------------------------------------------
vlan-id
interface
static-ip
static-mask
ip
mask
mac
dhcp-status
ipv6-status
ipv6-autoconfig-status
static-ipv6
static-ipv6-prefix-length
DLINK-WLAN-AP# get untagged-vlan
Property Value
---------------
vlan-id 1
status down
DLINK-WLAN-AP#

Configuring IEEE 802.1X Authentication

On networks that use IEEE 802.1X, port-based network access control, a supplicant (client) cannot gain access to
the network until the 802.1X authenticator grants access. If your network uses 802.1X, you must configure 802.1X
authentication information that the AP can supply to the authenticator.
If your network uses IEEE 802.1X see
how to configure 802.1X by using the Web interface.
January 2015

Table 5 - CLI Commands for Ethernet Setting

Value
123
brtrunk
10.90.90.91
255.0.0.0
10.90.90.91
255.0.0.0
00:05:5E:80:70:00
down
up
up
::
0
"Configuring IEEE 802.1X Authentication" on page 19
Commands
set management dhcp-status up
set management dhcp-status down
set management static-ip <ip_address>
For example:
set management static-ip 10.10.12.221
set management static-mask <netmask>
For example:
set management static-mask 255.255.255.0
set static-ip-route gateway <ip_address>
For example:
set static-ip-route gateway 10.10.12.1
get host dns-via-dhcp
set host dns-via-dhcp down
set host static-dns-1 <ip_address>
set host static-dns-2 <ip_address>
For example:
set host static-dns-1 192.168.23.45
set host dns-via-dhcp up
Unified Access Point Administrator's Guide
Section 2 - Getting Started
for information about
Page 19