Detailed Access Point Rf Scan Status; Table 43: Access Point Rf Scan Status - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
D A P
ETAILED CCESS
The detailed status for access points detected during the RF scan shows the information on the summary page plus some
additional information learned from the beacon frame, such as transmission rate.
The following table shows the information the Access Point RF Scan Status page shows for an individual access point.
Field
MAC Address
SSID
Physical Mode
Channel
Status
Transmit Rate
Beacon Interval
Discovered Age
Age
• Click Refresh to update the screen with the most current information.
• Click Back to return to the list of Rogue/RF Scan Access Points.
Page 140
RF S S
OINT CAN TATUS

Table 43: Access Point RF Scan Status

Description
The Ethernet MAC address of the detected AP, this could be a physical radio interface or VAP
MAC. For D-Link Access Points this is always a VAP MAC address.
Service Set ID of the network, this is broadcast in detected beacon frame.
Indicates the 802.11 mode being used on the AP.
Transmit channel of the AP.
Indicates the managed status of the AP, whether this is a valid AP known to the switch or a
Rogue on the network. The valid values are:
• WS Managed - The neighbor AP is managed by this switch, the neighbor AP status can be
referenced using its base MAC address.
• Peer WS Managed - The neighbor AP is managed by another switch within the peer group.
• Acknowledged Rogue - The AP is configured as a valid AP entry (local or RADIUS), it has
been acknowledged and is not reported as Rogue.
• Ad Hoc Rogue - The AP neighbor was detected participating in an ad hoc network.
Indicates the rate at which the AP is currently transmitting data.
Beacon interval for the neighbor AP network.
Time in seconds since this AP was first detected in an RF scan.
Time in seconds since this AP was last detected in an RF scan.
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10