Access Point Cli Commands; Configuring Basic Settings; Table 34. Basic Setting Commands - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

D-Link Unified Access Point Administrator's Guide

Access Point CLI Commands

This section describes the commands you use to view and configure the Unified Access Point.
The CLI commands correspond to tasks you can accomplish by using the Web-based user
interface (UI). In some cases, the CLI get command provides additional details not available
through the Web UI.
NOTE: CLI commands for MAC Authentication and Load Balancing are not
The CLI performs validation on individual property values in a
to see if different property values are consistent with each other. For example, it would not
provide any error if a radio's mode was set to "a" and its channel was set to "1". (Even though
"1" is not a valid channel in "a" mode, it is a valid channel in "g" mode.) In cases where the
configuration is left in an inconsistent state, the services associated with the configuration may
not be operational. Therefore, it is important to consult the class and property reference to
understand the acceptable values for properties given the values of other properties. For more
information, see

Configuring Basic Settings

The following CLI command examples correspond to tasks you can accomplish on the Basic
Settings tab of the Web UI for access points.
NOTE: Before you configure the basic settings, make sure you are familiar with the

Table 34. Basic Setting Commands

Action
Get the following information
about the management interface
on the AP:
• VLAN ID
• Interface Name
• Static IP address (if DHCP is
not used)
• Static Subnet Mask
• IP Address
• Subnet Mask
• MAC Address
• DHCP Status
Get the Firmware Version
134 © 2001-2008 D-Link Corporation. All Rights Reserved.
available. You must use the Web interface to view and configure these
features on the access point.
"CLI Classes and Properties Reference"
names of the interfaces as described in
page 132. The interface name you reference in a command determines
whether a setting applies to a wired or wireless interface, the Internal
network, or to radio "one" or radio "two."
on page 150.
"Interface Naming Convention"
Command
To show all settings:
get management
To show specific settings:
get management vlan-id
get management interface
get management static-ip
get management static-mask
get management ip
get management mask
get management mac
get management dhcp-status
get system version
or , but does not check
set add
on