Ip Routing; Static Routing Setup - D-Link DAP-3310 User Manual

Section 3 - Configuration
This page will allow you to configure the built-in routing
protocols that the DAP-3310 allows when in certain
operating modes.
OSPF Service Select to either Disable or Enable the AP from
offering OSPF service.
RouterID: Select the interface that the AP will broadcast
OSPF from. This should be the main interface
that will connect to the local network.
Network Selecting this checkbox will allow you to enter
(Internal): an area that will be used by the static routing
setup on the internal network.
Network Selecting this checkbox will allow you to enter
(External): an area that will be used by the static routing
setup on the external network
Distribute RIP Enabling this option will allow the router to
over OSPF: broadcast the RIP routing protocol over OSPF.
Select to either Disable or Enable the AP from offering RIP routing services.
RIP Service:
Side (Devices): Select the checkbox for the interface that will allow clients to connect to.
Distribute Enabling this option will allow the router to broadcast the OSPF routing protocol over the RIP service.
OSPF over RIP:
Click Create.New.Route.Table to define specific routes that will be handled by the AP.
D-Link DAP-3310 User Manual

IP Routing

Static Routing Setup

45