Voice Mail Disconnect Table - Vodavi Starplus Triad-S System Programming Manual

Voice Mail Outpulsing Table

Voice Mail Disconnect Table

Technical Manuals Online! - http://www.tech-man.com
Programming Steps
1. Press the DISCONNECT TABLE 8 flexible button (FLASH 66,
Button #9). This table number is used for the voice mail disconnect
signal.
2. Enter up to 12 digits used for the disconnect signal, including [ ] and
[#], TRANS button = pause.
V OICE D IS E
MAIL
3. Press HOLD to save the entry. A confirmation tone is heard and the
display updates.
Description
A disconnect signal can be programmed into the
the VM system that a call has been abandoned. This is accomplished
through in-band signaling. If a CO or Intercom disconnect signal is
detected, the Triad-S
in the voice mail disconnect table to the voice mail port. This can be any
digit stream up to 12 digits including [ ] and [#].
This table serves all eight voice mail groups. When no digits are
programmed in the disconnect table, silence is provided to the voice mail
port followed by busy tone to aid the voice mail system to recognize that
the caller has abandoned the call.
The Triad-S System provides Loop Supervision monitoring while a CO call
is connected to a port designated as voice mail.
Loop Supervision must be enabled on the CO lines (in CO Line
programming) for the VM Disconnect feature to operate.
By default, there are no entries in the Disconnect Table (Table #8).
System sends a series of DTMF digits programmed
Triad-S System to notify
8-9