Voice Mail Outpulsing Table
Voice Mail Disconnect Table
Programming Steps
1. Press the DISCONNECT TABLE 8 flexible button (FLASH 66,
2. Enter up to 12 digits used for the disconnect signal, including [ ] and
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
A disconnect signal can be programmed into the
notify the VM system that a call has been abandoned. This is
accomplished through in-band signaling. If a CO or Intercom disconnect
signal is detected, the
programmed in the voice mail disconnect table to the voice mail port.
This can be any digit stream up to 12 digits including [ ] and [#].
This table serves all eight voice mail groups. When no digits are
programmed in the disconnect table, silence is provided to the voice mail
port followed by busy tone to aid the voice mail system to recognize that
the caller has abandoned the call.
The
call is connected to a port designated as voice mail.
By default, there are no entries in the Disconnect Table (Table #8).
Button #9). This table number is used for the voice mail disconnect
signal.
[#], TRANS button = pause.
V OICE
D IS E
MAIL
display updates.
Triad 1/2/3
System provides Loop Supervision monitoring while a CO
Loop Supervision must be enabled on the CO lines (in CO Line
programming) for the VM Disconnect feature to operate.
Triad 1/2/3
System sends a series of DTMF digits
Triad 1/2/3
System to
8-9