Ip Prefix List Commands - Dell Force10 S4810P Reference Manual

count
byte
log
monitor
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version
6.1.1.0
Usage
When you use the log option, the CP processor logs details about the packets that match.
Information
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets' details.
Related
deny
Commands
permit

IP Prefix List Commands

When you create an access-list without any rule and then apply it to an interface, the ACL behavior reflects implicit
permit.
Use these commands to configure or enable IP prefix lists.
298
•
•
(OPTIONAL) Enter the keyword count to count packets the filter
processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL, E-Series only) Enter the keyword log to log the packets.
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the
Guide .
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the monitor option.
Introduced on the E-Series.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
– configures a filter to drop packets.
– configures a filter to forward packets.
llc - is the IEEE 802.3 frame format.
snap - is the IEEE 802.3 SNAP frame format.
FTOS Configuration