Brocade Communications Systems StoreFabric SN6500B Reference page 924

5
ZONE-1054
ZONE-1054
Message
Default Zone All Access mode is set with Frame Redirection zones.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the Default Zone All Access mode will not grant all access behavior when the frame
redirection zones are defined.
Recommended
Remove frame redirection zones or set the Default Zone access mode to No Access using the defzone
Action --noaccess command.
ZONE-1057
Message
TI Zone <TI zone name> has domain <Domain ID of switch with version pre6.4.0>
running pre FOS6.4.0 firmware. TI member (Domain <Domain ID of higher port index>,
Index <Higher port index>) is not supported.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an unsupported port index (> 511) is present in the TI zone path or the routing may not be
set up correctly.
Recommended
Remove the port index from the TI zone using the zone --remove name command.
Action
ZONE-1058
Message
Domain <Domain ID of the switch that becomes unreachable> present in TI zone <TI
zone name> became unreachable due to failover disabled mode.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the domain present in the TI zone path is unreachable. This occurs if the TI zone paths are
unavailable or the TI zone is set up incorrectly.
Recommended
Verify that the paths defined by TI zones are online or remove the domain from the TI zone using the
zone --delete name command.
Action
902
Fabric OS Message Reference
53-1002749-01