BL Messages
BL-1000
Message
Initializing ports...
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the switch has started initializing the ports.
Recommended
No action is required.
Action
BL-1001
Message
Port initialization completed.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the switch has completed initializing the ports.
Recommended
No action is required.
Action
BL-1002
Message
Init Failed: slot <slot number> DISABLED because internal ports were not ONLINE,
<list of internal port number not ONLINE>.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the blade initiation failed because one or more of the internal ports was not online. The
blade is faulted.
Recommended
Make sure that the blade is seated correctly.
Action
If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test
(POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or
have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware
problems.
Additional blade fault messages precede and follow this error, providing more information. Refer to other
error messages for recommended action.
If the message persists, replace the blade.
Fabric OS Message Reference
53-1002749-01
5
BL-1000
163