Brocade Communications Systems StoreFabric SN6500B Reference page 169

AUTH-1011
Message
Failed to register for failover operation: switch <switch number> error <error
code>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1012
Message
Authentication <code> is rejected: port <port number> explain <explain code>
reason <reason code>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified authentication is rejected because the remote entity does not support
authentication.
Recommended
Verify the hash type, protocol, group, and authentication policy using the authutil --show command.
Action
AUTH-1013
Message
Cannot perform authentication request message: port <port number>, message code
<message code>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the system is running low on resources when receiving an authentication request. Usually
this problem is transient. The authentication may fail.
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Fabric OS Message Reference
53-1002749-01
5
AUTH-1011
147