Brocade Communications Systems StoreFabric SN6500B Reference page 881

Recommended
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
Action transfers; then execute the supportSave command and contact your switch service provider.
TRCE-1004
Message
Trace dump<slot on which the trace dump occurs> was not transferred because trace
auto-FTP disabled.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that trace dump files have been created on the switch or the specified slot, but the trace dump
files were not automatically transferred from the switch because auto-FTP is disabled.
Recommended
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
Action supportSave command and contact your switch service provider.
TRCE-1005
Message
FTP Connectivity Test failed due to error.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the connectivity test to the FTP host failed because of reasons such as a wrong FTP
address, FTP site is down, network is down, and so on.
Recommended
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
Action supportSave command and contact your switch service provider.
TRCE-1006
Message
FTP Connectivity Test succeeded to FTP site ' <FTP target configured by users> '.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that a connectivity test to the FTP host has succeeded. This feature is enabled using the
supportftp -t command.
Recommended
No action is required.
Action
Fabric OS Message Reference
53-1002749-01
5
TRCE-1004
859