Brocade Communications Systems StoreFabric SN6500B Reference page 314

5
EM-1061
EM-1061
Message
Synchronization halted. Remove all blades of type <Blade Type Id> or upgrade your
standby CP, then reboot or run haSyncStart.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the blade in the system is not supported by the firmware on the standby control processor
(CP).
Recommended
Remove all blades of the specified type or upgrade the standby CP. After an appropriate action is taken,
Action restart the standby CP or execute the haSyncStart command to enable the high availability (HA) state
synchronization. Until this is done, the system will remain out of synchronization.
EM-1062
Message
Blade in slot <Slot Id> faulted as it exceeds the maximum support limit of <Limit>
blades with Blade ID <Blade Type Id> in the chassis.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that too many blades of a particular type are in the system.
Recommended
Remove the faulted blade.
Action
EM-1063
Message
Blade in slot <Slot Id> faulted because it exceeds the maximum support limit of
<Limit> blades with Blade IDs <Applicable blade Type IDs> in the chassis.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that too many blades of a set of particular types are in the system.
Recommended
Remove the faulted blade.
Action
292
Fabric OS Message Reference
53-1002749-01