Brocade Communications Systems StoreFabric SN6500B Reference page 871

SWCH-1019
Message
Device <wwn name of device> tries to FLOGI, reject FLOGI as persistent PID is set
on device and port <port number> has user area <area> bound to it.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates a WWN-PID and port address binding collision.
Recommended
The persistent PID is set on the device and the requested area cannot be assigned because the port it is
Action trying to log in through has a different area bound to it. Remove the WWN-PID binding using the
wwnaddress --unbind command or remove the port address binding using the portaddress --unbind
command and then re-enable the port.
SWCH-1020
Message
HA state out of sync: Standby CP (ver = <standby SWC version>) does not support
QoS links to AG(Active CP version = <active SWC version>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support links to Access Gateway running
quality of service (QoS).
Recommended
Load a firmware version on the standby CP that supports QoS links to Access Gateway by using the
Action firmwareDownload command.
SWCH-1021
Message
HA state out of sync: Standby CP (ver = <standby SWC version>) does not support
Dynamic area on default switch (Active CP version = <active SWC version>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support dynamic area on the default switch.
Recommended
Load a firmware version on the standby CP that supports dynamic area on the default switch by using the
Action
firmwareDownload command.
Fabric OS Message Reference
53-1002749-01
5
SWCH-1019
849