Brocade Communications Systems StoreFabric SN6500B Reference page 470

5
FW-1051
FW-1051
Message
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) voltage has risen above the high
boundary. High voltages indicate possible hardware failures.
Recommended
Frequent voltage fluctuations indicate that the SFP is deteriorating. Replace the SFP.
Action
FW-1052
Message
<Label>, is between high and low boundaries(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) voltage has changed from a value
outside of the acceptable range to a value within the acceptable range.
Recommended
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
Action installation.
FW-1053
Message
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) Power on Hours has fallen below the
low boundary.
Recommended
Configure the low threshold to 1 so that the threshold triggers an alarm when the value falls to 0
Action (Out_of_Range). If continuous or repeated alarms occur, replace the SFP before it deteriorates.
448
Fabric OS Message Reference
53-1002749-01