Brocade Communications Systems StoreFabric SN6500B Reference page 642

5
MS-1009
MS-1009
Message
RLIR event. Slot/Port <slot number>/<port number> (0x<PID (hex)>). Device Port Tag
is 0x<port tag>. <message text>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a registered link incident record (RLIR) has been generated for one of the actions indicated by
the message value.
The message value can be one of the following:
•
•
•
•
•
Recommended
Persistent RLIR incidents are likely the result of SAN hardware problems such as bad cables or small
Action form-factor pluggable (SFP) transceivers. If the message persists, replace hardware.
MS-1021
Message
MS WARMBOOT failure(FSS_MS_WARMINIT failed. Reason=<failure reason>).
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the Fabric OS state synchronization (FSS) warm recovery failed during the WARM INIT
phase of a reboot.
Recommended
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
Action transfers; then execute the supportSave command and contact your switch service provider.
MS-1022
Message
Management Server Platform Service <Activated or Deactivated>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Management Server (MS) platform service is being activated or deactivated.
Recommended
No action is required.
Action
620
Exceeded bit error rate threshold
Loss of signal or synchronization
Not operational seq recognized
Primitive sequence timeout
Unrecognized link incident
Fabric OS Message Reference
53-1002749-01