Brocade Communications Systems StoreFabric SN6500B Reference page 746

5
SEC-1154
SEC-1154
Message
PID change failed: <Reason> <defined status> <active status>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that either the defined or the active policy could not be updated. If the policy database is very
large, it might not be able to change the index/area because the new policy database exceeds the
maximum size. This message can also be caused when the switch is short of memory. The status values
can be either defined, active, or both. A negative value means that a policy set was failed by the daemon.
Recommended
Reduce the size of the policy database.
Action
SEC-1155
Message
PID change failed: <Reason> <defined status> <active status>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that either the defined or active policy was too large after modifying the index/area ID. The
status values can be either defined, active, or both. A negative value means that a policy set was failed
by the daemon.
Recommended
Reduce the size of the specified policy database.
Action
SEC-1156
Message
Change failed: <Reason> <defined status> <active status>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the security daemon is busy. The status values can be defined, active, or both. A negative
value means that a policy set was failed by the daemon.
Recommended
For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands may
Action take a few minutes to propagate throughout the fabric. Make sure to wait a few minutes between
executing commands so that your commands do not overlap in the fabric.
724
Fabric OS Message Reference
53-1002749-01