Brocade Communications Systems StoreFabric SN6500B Reference page 171

AUTH-1018
Message
Invalid value to check protocol type: port <port number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1020
Message
Failed to create timer for authentication: port <port number>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that an authentication message timer was not created. Usually this problem is transient. The
authentication may fail.
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1022
Message
Failed to extract <data type> from <message> payload: port <port number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the authentication process failed to extract a particular value from the receiving payload.
Usually this problem is transient. The authentication may fail.
Recommended
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
Action switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Fabric OS Message Reference
53-1002749-01
5
AUTH-1018
149