Brocade Communications Systems StoreFabric SN6500B Reference page 854

5
SULB-1009
The following descriptions explain the causes of some common error messages:
•
•
•
•
•
•
The following table lists the
in the
TABLE 9
Upgrade state
SUS_PEER_CHECK_SANITY
SUS_PEER_FWDL_BEGIN
SUS_SBY_FWDL_BEGIN
SUS_PEER_REBOOT
SUS_SBY_REBOOT
SUS_SBY_FABOS_OK
SUS_PEER_FS_CHECK
SUS_SELF_FAILOVER
SUS_SBY_FWDL1_BEGIN
SUS_SELF_FWDL_BEGIN
SUS_SELF_COMMIT
SUS_SBY_FWC_BEGIN
SUS_SBY_COMMIT
SUS_SBY_FS_CHECK
832
0x15 - "Failed to download RPM package." If this error occurs immediately after firmware
download is started, the firmware on the switch may be two releases older than the requested
firmware. The firmware download operation supports firmware upgrades within two feature
releases (a feature release is indicated by a major number and a minor number; for example,
X.Y). In this case, you will need to upgrade to an intermediate version before downloading the
desired version. If this error occurs in the middle of a firmware download, the firmware in the
file server may be corrupted or there may be a temporary network issue. In this case, retry the
command. If the problem persists, contact your system administrator.
firmwareDownload
0x18 - "Error in getting lock device for firmware download". This error can be due to another
firmware download is already in progress. Run the
verify that this is the case. Wait for the current session to finish before proceeding.
0x23 - "Firmware download timed out." This error may occur because the
firmwareDownloadStatus
It is most often caused by network issues. If the problem persists, contact your system
administrator.
0x24 - "Out of disk space." This error may occur because some core dump files have not been
removed from the filesystem and are using up disk space. Remove these core dump files by
using the command before proceeding.
supportSave
0x29 - "The pre-install script failed." This error may be caused by an unsupported blade type.
Remove or power off the unsupported blades before proceeding.
0x2e - "Invalid RPM package." This error may be caused by an inconsistent firmware image
loaded on the file server. It may also be caused by temporary networking issues. Reload the
firmware packages on the file server and then retry the
problem persists, contact your system administrator.
firmwareDownload
process the error occurred.
firmwareDownload
Upgrade state and code value
firmwareDownloadStatus
command has not completed within the predefined timeout period.
state names and code values. They indicate where
command to
command. If the
firmwareDownload
Code
0x21
0x22
0x23
0x24
0x25
0x26
0x27
0x28
0x29
0x2a
0x2b
0x2c
0x2d
0x2e
Fabric OS Message Reference
53-1002749-01