Brocade Communications Systems StoreFabric SN6500B Reference page 851

TABLE 7
Status message
"Standby CP failed to boot up."
"Standby CP booted up with new firmware."
"Standby CP failed to boot up with new firmware."
"Firmware download has completed successfully on standby CP."
"Firmware download has started on standby CP. It might take up to 10 minutes. "
"Firmware download has completed successfully on standby CP."
"Standby CP reboots."
"Standby CP failed to reboot."
"Firmware commit has started on standby CP."
"Firmware commit has completed successfully on standby CP."
"Standby CP booted up with new firmware."
"Standby CP failed to boot up with new firmware."
"Firmware commit has started on both active and standby CPs."
"Firmware commit has completed successfully on both active and standby CPs."
"Firmware commit failed on active CP."
"The original firmware has been restored successfully on standby CP."
"Unable to restore the original firmware on standby CP."
"Standby CP reboots."
"Standby CP failed to reboot."
"Standby CP booted up with new firmware."
"Standby CP failed to boot up with new firmware."
"There was an unexpected reboot during the firmware download operation. The
command is aborted."
"Standby CP was not responding. The command is aborted."
"Firmware commit has started on both active and standby CPs. Run the
firmwareDownloadStatus
status."
"Firmware commit has started on the local CP. Run the
and
"Firmware commit has started on the remote CP. Run the
firmwareDownloadStatus
status."
"Run the
firmware status."
"The
"The original firmware has been restored successfully."
"Remote CP is restoring its secondary partition."
"Local CP is restoring its secondary partition."
Fabric OS Message Reference
53-1002749-01
Status messages and status codes (Continued)
and
firmwareShow
commands to see the firmware status."
and
firmwareDownloadStatus
firmwareDownload command has completed successfully."
firmwareShow
commands to see the firmware
firmwareDownloadStatus
firmwareShow commands to see the firmware
firmwareShow
and commands to see the
5
SULB-1009
Status code
0x6f
0x70
0x71
0x72
0x73
0x74
0x75
0x76
0x77
0x78
0x79
0x7a
0x7b
0x7c
0x7d
0x7e
0x7f
0x80
0x81
0x82
0x83
0x84
0x85
0x86
0x87
0x88
0x89
0x8a
0x8b
0x8c
0x8d
829