Brocade Communications Systems StoreFabric SN6500B Reference page 674

5
PLAT-1003
PLAT-1003
Message
<Info message> Slot <Blade Slot number> C/BE: 0x<Captured Command/Byte-Enables
data> ADBUS: 0x<Captured AD bus data> misc_intr 0x<Bridge reset interrupts>.
Message Type
LOG | FFDC
Severity
CRITICAL
Probable Cause
Indicates that peripheral component interconnect (PCI) bus hang was detected.
Recommended
Replace the field-replaceable unit (FRU).
Action
PLAT-1004
Message
Switch has older FPGA rev 0x<FPGA version already installed in HW>. Upgrade to
newer rev 0x<FPGA version which Fabric OS carries> using the fpga_update command.
Message Type
LOG | FFDC
Severity
CRITICAL
Probable Cause
Indicates that Fabric OS has older field-programmable gate array (FPGA) version. This message is
applicable only to Brocade 5470.
Recommended
Upgrade FPGA to new version.
Action
PLAT-1072
Message
The chassis is disabled because no Core Blades are available. Insert/replace one
or both Core Blades and run chassisenable.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the chassis has been disabled because of the unavailability of the core blades. There must
be at least one core blade in enabled state for the chassis to be considered ready. All core blades are
either missing, faulted, or powered off. This results in all logical switches (and ports) being disabled.
Recommended
Make sure that all core blade slots have core blades inserted and their ejector switches are closed.
Action Power on core blades that are powered off, and power cycle or replace the core blades that are faulted.
Run the chassisenable command to re-enable the ports.
Running the fastboot or reboot command will also result in enabling the logical switches and ports.
652
Fabric OS Message Reference
53-1002749-01