Brocade Communications Systems StoreFabric SN6500B Reference page 338

5
FABR-1041
FABR-1041
Message
Port <Port that is being disabled> is disabled due to trunk protocol error.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a link reset was received before the completion of the trunking protocol on the port.
Recommended
Enable the port by running the portEnable command.
Action
The port may recover by re-initialization of the link.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FABR-1043
Message
Detected Fabric ID conflict with remote (not neighbor) switch <Switchname> (domain
<Domain ID>), FID <Fabric ID>. No local E_Ports disabled.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the remote switch has a Fabric ID (FID) conflict with the local switch. But no ports are
disabled because the remote switch is not an adjacent to the local switch.
Recommended
Make sure that all the switches in the fabric have the same FID or upgrade the switch firmware to a
Action VF-capable firmware.
FABR-1044
Message
Detected Fabric ID conflict with neighbor switch <Switchname> (domain <Domain
ID>), FID <Fabric ID>. E_Ports (<Number of E_Ports disabled>) connected to the
switch are disabled.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the neighbor switch has a Fabric ID (FID) conflict with the local switch. All E_Ports directly
connected to the conflicting switch are disabled.
Recommended
Make sure that all the switches in the fabric have the same FID or upgrade the switch firmware to a
Action VF-capable firmware.
316
Fabric OS Message Reference
53-1002749-01